Turn ignition to ON without start the engine!!!.Connect Tech 2 scanner to vehicle. Power on device – “Tech 2” is displayed on the screen, then press “ENTER”.On ‘Select Diagnostic Tool and Programming Process’ (picture below) screen make the desired selection forĢ) the reprogramming of an ECU that was not exchanged or the replacement/programming of a new ECU Select the application ‘Service Programming System’ on the TIS 2000 start page.Ĥ.To register the hardware key select ‘Hardware Key Registration’ in the menu ‘Configuration’. Hardware keys that have already been registered are still valid!
#Gm tech 2 programer alternative code#
Note: The hardware key (HWK) has to be registered prior to working with ‘Service Programming System’. To register a hardware key, the form that is enclosed with the hardware key kit has to be filled in and sent to the address at the top. In case the form is missing, the document is also in the TIS 2000 newsletter (see icon in the TIS 2000 tool bar). At first, the user receives a temporary code until the key is registered on the next TIS 2000 CD. If you need to program Saab ECU, you had to use Saab TIS2000 and USB dongle.
#Gm tech 2 programer alternative software#
TIS2000 will not work on 2007 up GM, and software must work together with TIS2000 USB key. Here is the step-by-step instruction on programming GM (General Motors) ECUs with Tech2 scanner and SPS (Service Programming System) application in TIS2000.īefore using the SPS, make sure that the Tech 2 scan tool and the pc contain the latest software, the battery of the vehicle is fully charged, only the ignition is on power, and all cables are connected properly.
0 kommentar(er)
